Where's our Kenne Bell Superchargers Coyote guys?
I know there's not a ton of them out there, but we've been working on a little project for the KB guys with our friends and vendor partners over at ZPE/GripTec! This is a hub and ring pulley setup that will allow you to change your outer ring size to your boost needs with ease! Previously, and for the duration of KB's existence, they had only offered a couple pulley sizes, which were non-shouldered. This new hub & ring setup will allow you to exceed those past offerings, and we've added in some micro ablation machining to the pulley ring, as well as adding front & rear shoulders to keep your belts in place, centered, and to keep them from slipping!
Lund Racing says the Datalogs looked Gucci on the 3.20" pulley! Swapped to the 2.90" pulley today and we'll see what they say on this new unit! As a teaser, we saw over 84lbs/min of airflow on the datalog already ;-) Looking forward to dyno testing later this week!
